Gunprimer Joint Guard

This is a special reinforcing tape to recover the looseness of joints and moving parts of the mechanical model.

■ How to use

1. Select and paste a joint guard with a size that covers about 2/3 of the loose parts.

2. Use one to three sheets according to the degree of looseness if necessary.

3. When holding heavy parts, attach a small amount of instantaneous adhesive to the side of the tape and dry it. (See the video2 below)

【Important point】

1. Be sure to remove the grease and dust from the surface before applying. 

2. All parts are ready to operate immediately after the JOINT GUARD is attached. However, for ball joints supporting heavy parts, it is recommended to start after 24 hours after applying a small amount of super glue.

Component : 1sheet (1,054 pieces)